Common Issues With Sectional Garage Doors and How To Fix Them

A typical problem is when a sectional garage door becomes stuck or jammed. This can occur due to obstructions in the tracks, misaligned tracks, or opener issues.

How to Fix It:

• Check for obstructions: Inspect the tracks for debris or grime that might be blocking movement. Clean them thoroughly.
• Realign the tracks: If they’re misaligned, the door won’t open or close correctly. Call a professional for safe track realignment.
• Test the opener: If the problem persists, verify the batteries in your remote, ensure the opener is powered, and reset it if necessary. If it’s still not functioning, consider a service visit.

Excessive noise can be a sign of loose hardware, worn rollers, or a lack of lubrication.

How to Fix It:

• Replace Worn Rollers: If rollers are shot, they can cause loud operation. Contact an Accredited B&D Dealer for a professional replacement.
• Lubricate Moving Parts: Proper lubrication of rollers, tracks, hinges, and springs helps cut down on noise. Use a dry or silicone-based garage door lubricant avoid grease, which attracts dirt and can lead to further trouble.

The springs on a sectional garage door are under high tension to lift and lower the door. A broken spring can make the door tough or impossible to operate.

How to Fix It:

• Call a Professional: Due to the high tension, fixing or replacing springs can be hazardous. Always hire a trained garage door technician to do this and ensure your door’s balance is correct afterward.

Sometimes, a garage door may start closing, only to reverse suddenly. This could be tied to auto-reverse features or a misalignment of safety beams.

How to Fix It:

• Check the Safety Beams: If safety beams are installed, ensure they’re aligned and not obstructed by dirt or cobwebs.
• Adjust the Limit Settings: These control how far the door travels before fully closing. If set incorrectly, the door might think it’s hitting an obstacle and reverse. Contact an Accredited B&D Dealer to service and adjust your door’s limit settings. They’ll also inspect the auto-reverse function.

A delayed response when you press the remote may be linked to opener issues or interference from other electronics.

How to Fix It:

• Replace Remote Batteries: Start simple swap the batteries in your remote and see if that speeds things up.
• Reduce Interference: Electronics or LED bulbs in or near the garage could interfere with the signal. If turning them off doesn’t help, arrange a repair or service through an accredited dealer.